Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Recover the refrigerant with a recovery/ recycling/ charging station. |
3. |
When the engine is cool, drain the engine coolant from the radiator.
|
4. |
Remove the heater & blower assembly.
(Refer to Heating,Ventilation, Air Conditioning - "Heater Unit") |
5. |
Remove the blower unit (B) from heater unit after loosening 3 screws. |
6. |
Loosen the heater unit lower case mount screw and then remove the heater unit lower case (A). |
7. |
Remove the evaporator core (A).
|
8. |
Installation is the reverse order of removal
|
Opening the trunk
Press the trunk unlock button for more than 1 second on the smart key.
Press the switch on the trunk handle with the smart key in your possession
(2).
Insert the mechanical key of the smar ...
ETC (Electronic Throttle Control) System Repair procedures
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Throttle ...
Engine Control Module (ECM) Schematic Diagrams
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [ELG-A]
Pin No.DescriptionConnected to1-?2-?3-?4Immobilizer Lamp control outputImmobilizer Lamp [Without Button Engine Sta ...