Removal and Installation |
[LH] |
1. |
Disconnect the LH front and rear heated oxygen sensor (HO2S) connector.
|
2. |
Remove the front muffler.
(Refer to Intake And Exhaust System - "Front Muffler") |
3. |
Remove the cooling fan assembly.
(Refer to Cooling System - "Cooling Fan") |
4. |
Remove oil level gauge assembly.
(Refer to Lubrication System - "Oil Level Gauge & Pipe") |
5. |
Remove the LH exhaust manifold heat protector (A).
|
6. |
Remove the LH exhaust manifolds stay (A),and then remove the LH exhaust manifold (B) and gasket.
|
7. |
Install in the reverse order of removal.
|
[RH] |
1. |
Disconnect the RH front and rear heated oxygen sensor (HO2S) connector.
|
2. |
Remove the surge tank.
(Refer to Intake And Exhaust System - "Surge Tank") |
3. |
Remove the front muffler.
(Refer to Intake And Exhaust System - "Front Muffler") |
4. |
Remove the RH exhaust manifold heat protector (A).
|
5. |
Remove the RH exhaust manifolds stay (A),and then remove the RH exhaust manifold (B) and gasket.
|
6. |
Install in the reverse order of removal.
|
Change to "winter weight" oil if necessary
In some climates it is recommended that a lower viscosity "winter weight" oil
be used during cold weather. See section 8 for recommendations. If you aren't sure
what weight oil you sho ...
Hazard Lamp Switch Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the center console upper assembly (A) with hazard lamp switch.
Apply the protective tapes to the center ...
Interior Body Repair
Interior A
Front pillar trim mounting hole (O8.5) Curtain airbag mounting hole (O6.6) Cowl crossbar mounting hole (O9) Front door checker mounting hole (O13)Cowl side trim mounting hole (6.5X18) ...