Replacement |
1. |
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported. |
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Loosen the wheel speed sensor mount bolt and then remove the wheel speed sensor (A) from knuckle.
|
4. |
Remove the tie rod end ball joint (A) from the knuckle.
|
5. |
Remove driveshaft coking nut(A) from the front hub under applying the brake.
|
6. |
Remove the lower arm (A) from the knuckle.
|
7. |
Disconnect the driveshaft (A) from the front hub assembly.
|
8. |
Remove the driveshaft cover (A). |
9. |
Loosen the mounting bolts and then remove the inner shaft (A) & driveshaft assembly (B). [RH]
|
10. |
Removing the driveshaft (A) from the transaxle (B) by using a pry bar (C) as shown below. [LH] |
11. |
Inatall in the reverse order of removal. |
12. |
Chek the alignment.
(Refer to Suspension System - "Alignment")
|
Repair procedures
Refrigerant System Service Basics
Refrigerant Recovery
Use only service equipment that is U.L-listed and is
certified to meet the requirements of SAE J2210 to remove
HFC-134a(R-134a) from the ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
AVN Remote Controller Description and Operation
Description
SWRC (Steering Wheel Remote Controller) is CAN communication
module which transmits the steering wheel remote controller signals.
This signal is different according to vehicle option ...