Hyundai Azera: Front Impact Sensor (FIS) Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Repair procedures

Removal

•	Removal of the airbag must be performed according to the precautions/ procedures described previously.

•	Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the air duct (A).

3.	Remove the radiator support upper member (A).

4.	Disconnect the front impact sensor connector (A).

5.	Remove the front impact sensor mounting nut (B).

6.	Remove the front impact sensor.

Installation

•	Do not turn the ignition switch ON and do not contact the battery cable while replacing the front impact sensor.

1.	Install the new front impact sensor.

Tighten the front impact sensor mounting nut.

Tightening torque :

6.8 ~ 9.2 N.m (0.7 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)

3.	Connect the front impact sensor connector.

4.	Install the radiator upper cover and air duct.

5.	Reconnect the battery negative cable.

After installing the Front Impact Sensor, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS) Components and Components Location

Components ...

Side Impact Sensor (SIS) Description and Operation

Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are ins ...

Hyundai Azera: Front Impact Sensor (FIS) Repair procedures

Front Impact Sensor (FIS) Components and Components Location

Side Impact Sensor (SIS) Description and Operation

See also:

Categories

Hyundai Azera Manuals