Hyundai Azera: Front Pillar Trim Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Interior Trim / Front Pillar Trim Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the front pillar trim (A).

2.

Installation is the reverse of removal.

•	Replace any damaged clips.

Front Pillar Trim Components and Components Location

Component Location 1. Front pillar trim ...

Center Pillar Trim Components and Components Location

Component Location 1. Center pillar lower trim2. Center pillar upper trim ...

See also:

Thermostat Repair procedures
Removal Removal of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. Do not remove the thermostat, even if the engine tends to overhea ...

Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and ...

Trunk Lid Trim Repair procedures
Replacement • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • Put ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com