Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel in the driver side.
|
3. |
Disconnect the connector and remove the side switch assembly by pushing both hooks. |
Installation |
1. |
Install the connector and crash pad side switch assembly. |
2. |
Install the negative (-) battery terminal. |
Components and Components Location
Component Location (1)
1. Head lamp (Low)2. Head lamp (High)3. Position lamp (LED)4. Front turn signal lamp5. Side marker6. Overhead console lamp (General/Panoramaroof)7. Room lamp (General) ...
Smart key Repair procedures
Smart Key
Smart Key Code Saving
1.
Connect the DLC cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.
2.
Select the vehicle model and then do ...
TPMS Receiver Schematic Diagrams
Circuit Diagram
Connector pin number
Pin NO.DiscriptionRemark1IGN2CAN_Low3-4Battery5CAN_High6Ground
...