Hyundai Azera: Glove Box Housing Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the crash pad side cover (A).

2.	Disconnect the stopper (B) from the glove box (A).

3.	Disconnect the air damper (A) from the glove box (B).

4.	Disconnect the pin (A) and then remove the glove box (B).

5.	After loosening the mounting screws, then remove the passenger's under cover (A).

6.	Disconnect the connector (A).

7.	After loosening the mounting screws, then remove the glove box housing (A).

8.	Disconnect the connectors (A).

9.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Glove Box Housing Components and Components Location

Component Location 1. Glove box housing ...

Steering Column Shroud Panel Components and Components Location

Component Location 1. Steering column shroud panel ...

See also:

Engine number
The engine number is stamped on the engine block as shown in the drawing. ...

Timing Chain Repair procedures
Removal 1. Set No.1 cylinder to TDC/compression. (1) Turn the crankshaft pulley clockwise and align its groove with the timing mark "T" of the lower timing chain cover. (2) Check that the m ...

Low aspect ratio tire (if equipped)
Low aspect ratio tires, whose aspect ratio is lower than 50, are provided for sporty looks. Because the low aspect ratio tires are optimized for handling and braking, it may be more uncomfortable t ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com