General |
1. |
Basically, all measurements in this manual are taken with a tracking gauge. |
2. |
When a measuring tape is used, check to be sure there is no elongation, twisting or bending. |
3. |
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual. |
Measurement Method |
Projected Dimensions |
1. |
These are the dimensions measured when the measurement
points are projected into the reference plane, and are the reference
dimensions used for body alterations. |
2. |
If the length of the tracking gauge probes is adjustable,
make the measurement by lengthening one probe by the amount equivalent
to the difference in height of the two surfaces. |
Actual-Measurement Dimensions |
1. |
These dimensions indicate the actual linear distance between
measurement points, and are the reference dimensions for use if a
tracking gauge is used for measurement. |
2. |
Measure by first adjusting both probes to the same length (A=A').
|
Measurement Point |
1. |
Measurements should be taken at the hole center. |
To defrost outside windshield
1. Set the fan speed to the highest (extreme right) position.
2. Set the temperature to the extreme hot (HIGH) position.
3. Press the defroster button ().
4. The air conditioning will be turned o ...
Components and Components Location
Component Location
1. Seat Memory Unit (IMS)2. IMS control switch3. IMS driver power seat control
...
Power Seat Control Switch Repair procedures
Inspection
With the power seat switch in each position, make sure that
continuity exists between the terminals below. If continuity is not as
specified, replace the power seat switch.
A : Lumb ...