Replacement |
|
1. |
Remove the head lamps.
|
2. |
Loosen the mud guard mounting screws. |
3. |
After loosening the mounting screws and clips, then remove the side sill molding (A). |
4. |
Using a screwdriver or remover, remove the fender garnish (A). |
5. |
Detach the clips and then remove the fender side cover (A). |
6. |
Using a screwdriver or remover, remove the delta garnish (A). |
7. |
After loosening the mounting screws and bolt, then remove the front bumper side mounting bracket (A). |
8. |
After loosening the fender mounting bolts and nut, then remove the fender (A). |
9. |
Installation is the reverse of removal. |
Catalytic Converter Repair procedures
Removal
[Catalytic Converter (WCC)]
1.
Remove the exhaust manifold.
(Refer to Engine Mechanical System - "Exhaust Manifold")
[Catalytic Converter (UCC)]
1.
Remove the Center Muffler.
...
Rear Back Armrest Cup Holder Repair procedures
Replacement
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and pan ...
Drive Belt Tensioner Repair procedures
Removal and Installation
1.
Remove the drive belt idler.
(Refer to Timing System - "Idler")
2.
Remove the drive belt auto tensioner (A).
Tightening torque
Bolt (B) :
81.4 ~ 85.3N.m (8.3 ...