Hyundai Azera: Hood Latch Release Handle Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Repair procedures

Replacement

1.

Using a screwdriver or remover, remove the hood release handle (A).

•	Use a 6mm hex bit to press the center until the handle easily pulls off the post.

2.

Installation is the reverse of removal.

•	Make sure the hood latch cable is connected properly.

•	Make sure the hood locks/unlocks and opens/closes properly.

Hood Latch Release Handle Components and Components Location

Component Location 1. Hood latch release handle ...

Hood Latch Components and Components Location

Component Location 1. Hood latch ...

See also:

Engine Oil Repair procedures
Replacement • Prolonged and repeated contact with mineral oil will result in the removal of natural fats from the skin, leading to dryness, irritation and dermatitis. I ...

Components and Components Location
Component Location 1. Hood switch2. Burglar horn3. IPM and RF antenna4. Key warning switch5. Front door switch6. Front door lock actuator & switch7. Rear door lock actuator & switch8. Rea ...

Rear parking assist system (If equipped)
The rear parking assist system assists the driver during reverse movement of the vehicle by chiming if any object is sensed within a distance of 47 in. (120 cm) behind the vehicle. This system is ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com