Hyundai Equus Manuals

Hyundai Azera: Hood Latch Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Hood Latch Repair procedures

Replacement
1.
Remove the front bumper cover.
(Refer to Front Bumper - "Front Bumper Cover")
2.
Detach the clips, then remove hood latch cover (A).

3.
Remove the hood latch (A) mounting bolts.

Tightening torque :
7.8 ~ 11.8N.m (0.8 ~ 1.2kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Disconnect the hood latch cable (A) and remove the hood latch (B).

5.
Installation is the reverse of removal.
   
Make sure the hood latch cable is connected properly.
Make sure the hood locks/unlocks and opens/closes properly.
Adjust the latch alignment.
Hood Latch Components and Components Location
Component Location 1. Hood latch ...

Trunk Lid
...

See also:

35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Oil Pan Repair procedures
Removal [Lower oil pan] 1. Drain the engine oil. (Refer to Lubrication System - "Engine Oil") 2. Remove the front muffler. (Refer to Intake And Exhaust System - "Front Muffler") 3. ...

Closing the fuel filler lid
1. To install the cap, turn it clockwise until it clicks one time. This indicates that the cap is securely tightened. 2. Close the fuel filler lid and push it lightly and make sure that it is secure ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com