Hyundai Azera: Trunk Lid Latch Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Latch Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Put on gloves to protect your hands.

1.	Remove the trunk lid trim. (Refer to Trunk Lid - "Trunk Lid Trim")

2.	Disconnect the trunk lid latch connector (A).

3.

Disconnect the cable (B), then loosen the latch assembly (C) mounting bolts and remove.

Tightening torque :

6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.

Installation is the reverse of removal.

•	Make sure the trunk lid locks/unlocks and opens/closes properly.

Trunk Lid Latch Components and Components Location

Component Location 1. Trunk lid latch ...

Trunk Lid Key Holder Components and Components Location

Component Location 1. Trunk lid key holder ...

See also:

Valve clearance
Inspect excessive valve noise and/or engine vibration and adjust if necessary. An authorized HYUNDAI dealer should perform the operation. ...

Emergency towing
If towing is necessary, we recommend you to have it done by an authorized HYUNDAI dealer or a commercial tow truck service. If towing service is not available in an emergency, your vehicle may be ...

Components and Components Location
Components 1. Front pillar trim2. Center pillar upper trim3. Rear pillar trim4. Cowl side trim5. Center pillar lower trim6. Front door scuff trim7. Rear door scuff trim ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com