Adjustment |
|
1. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim") |
2. |
Remove the rear door window glass mounting hole plug (B). |
3. |
Carefully move the rear door window glass (A) until the glass mounting bolts are visible, then loosen them. |
4. |
Check that the glass moves smoothly. |
• |
Make sure the door latches securely without slamming it. If
necessary adjust the striker (A): The striker nuts are fixed. The
striker can be fine adjusted up or down, and in or out. |
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker. The striker will not move much, but will give some adjustment. |
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches
properly, tighten the screws and recheck. |
|
1. |
Check that the door and body edges are parallel. |
2. |
Place the vehicle on a firm, level surface when adjusting the doors. |
3. |
Adjust at the hinges (A) :
|
4. |
Grease the pivot portions of the hinges indicated by the arrows. |
5. |
Check for water leaks. |
ICM (Integrated Circuit Module) Relay Box Components and Components Location
Component
Input/Output Specification
No.ConnectorNo.Connector1 -11 -2 -12 -3Burglar horn13 -4 -14 -5Engine room box(Horn 15A fuse)15GND6IPM(BCM : Burglar alarm h ...
Rear Curtain Switch Repair procedures
Removal
1.
Disconnect the negative(-) battery terminal.
2.
Remove the floor console upper cover.
(Refer to Body - "Floor Console Assembly")
3.
Remove the rear curtain switch connector (A) ...
MTS Antenna Components and Components Location
Components
...