Hyundai Azera: Roof Side Molding Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Roof Side Molding Repair procedures
| Replacement |
[General Type]
|
| 1. |
Using a screwdriver or remover, remove the roof side molding (A).
|
| 2. |
Installation is the reverse of removal.
|
[Panoramaroof Type]
|
| 1. |
Using a screwdriver or remover, remove the roof molding (A).
|
| 2. |
Installation is the reverse of removal.
|
Fender Garnish Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...
See also:
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wip ...
Ignition Coil Repair procedures
Removal and Installation
[LH]
1.
Disconnect the battery nagative terminal.
2.
Remove the engine cover.
3.
Disconnect the LH ignition coil connectors (A) and then remove the LH ignition ...
Front Seat Frame Assembly Components and Components Location
Component Location
1. Front seat back frame assembly2. Front seat cushion frame assembly
...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com