Hyundai Azera: Side Sill Molding Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Side Sill Molding Repair procedures
| Replacement |
|
| 1. |
Loosen the mounting screws. |
| 2. |
Using a screwdriver or remover, remove the side sill molding (A). |
| 3. |
Installation is the reverse of removal.
|
Waist Line Molding Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...
Panoramaroof
...
See also:
Fuel Tank Pressure Sensor (FTPS) Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the
evaporative emission control system and is installed on the fuel tank,
the fuel pump, or the canister. It checks the purge con ...
Deleting a Device
Press the key
Select [Phone]
Select [Paired Phone List]
From the paired phone list, select the device you want to delete and select the
button.
✽ NOTICE
When deleting the current ...
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com