Hyundai Azera: Cluster Fascia Panel Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Crash Pad / Cluster Fascia Panel Repair procedures

Replacement

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Take care not to scratch the body surface.

•	Put on gloves to protect your hands.

1.	Using a screwdriver or remover, remove the crash pad side cover (A).

2.	Using a screwdriver or remover, remove the fuse box cover (A).

3.	After loosening the mounting screws, then remove the crash pad lower panel (A).

4.	Disconnect the diagnosis connector (A) and connector (B).

5.	After loosening the mounting screws, then remove the crash pad garnish [LH] (A).

6.	After loosening the mounting screws, then remove the cluster fascia panel (A).

7.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Cluster Fascia Panel Components and Components Location

Component Location 1. Cluster fascia panel ...

Center Fascia Panel Components and Components Location

Component Location 1. Center fascia panel ...

See also:

Specifications
Specifications Purge Control Solenoid Valve (PCSV) ? Specification ItemSpecificationCoil Resistance (?)22.0 ~ 26.0 [20°C(68°F)] Fuel Tank Pressure Sensor (FTPS) ? Type: Piezo-Resistive Pr ...

Troubleshooting
Troubleshooting SymptomSuspect areaRemedyEngine misfire with abnormal internal lower engine noises.Worn crankshaft bearings.Loose or damaged engine drive plate.Replace the crankshaft and bearings ...

Fuel Tank Repair procedures
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) 2. Remove the fuel pump service cover (A) in the trunk. 3 ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com