Replacement |
|
1. |
Using a screwdriver or remover, remove the center facia side garnish (A). |
2. |
Remove the gear boots (B) and gear knob (A). |
3. |
Using a screwdriver or remover, remove the console upper tray complete (A). |
4. |
Disconnect the connectors (A). |
5. |
After loosening the mounting screws, then remove the cup holder tray (A). |
6. |
After loosening the mounting screws, then remove the center fascia tray (A). |
7. |
Disconnect the connectors (A). |
8. |
Using a screwdriver or remover, remove the center facia panel (A). |
9. |
Disconnect the connectors (A). |
10. |
Installation is the reverse of removal.
|
Radiator Hose Components and Components Location
Components
1. Radiator upper hose2. Radiator lower hose3. Hose clip4. Clamp
...
ETC (Electronic Throttle Control) System Schematic Diagrams
Circuit Diagram
...
Turn Signal Lamp Repair procedures
Removal
Door mirror turn signal lamp
1.
Disconnect the negative (-) battey terminal.
2.
Remove the mirror (A).
3.
Remove the outside mirror cover (A).
4.
Remove the lower cover (A) of ...