Hyundai Equus Manuals

Hyundai Azera: Rear Package Tray Trim Repair procedures - Interior Trim - Body (Interior and Exterior) - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Rear Package Tray Trim Repair procedures

Replacement
   
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
Put on gloves to protect your hands.
1.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH,RH]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

[Center]

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
Using a screwdriver or remover, remove the rear pillar trim (A).

4.
After loosening the mounting screws, then remove the luggage partition panel (A).

5.
After loosening the mounting screws, then remove the rear package tray trim (A).

6.
Installation is the reverse of removal.
   
Make sure the connector are connected in properly.
Replace any damaged clips.
Rear Package Tray Trim Components and Components Location
Component Location 1. Rear package tray trim ...

Trunk Trim
...

See also:

Starting the engine
WARNING - Proper footwear Always wear appropriate shoes when operating your vehicle. Unsuitable shoes (high heels, ski boots, sandals, etc.) may interfere with your ability to use the brake and acc ...

General Information
Basic Service Symbols There are five primary symbols used to complement illustrations. These symbols indicate the part to apply such materials during service. SymbolMeaningDo not reuse the p ...

Sunvisor Components and Components Location
Component Location 1. Sunvisor2. Retainer ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com