Hyundai Azera: Rear Back Armrest Cup Holder Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Back Armrest Cup Holder Repair procedures

Replacement

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

•	Put on gloves to protect your hands.

1.	Remove the rear back armrest. (Refer to Rear Seat - "Rear Back Armrest")

2.	Using a screwdriver or remover, remove the rear seat back armrest inner cover (A).

3.	Disconnect the connector (A).

4.	Using a screwdriver or remover, remove the rear seat armrest remote controll (A).

5.	Disconnect the connectors (A).

6.	After loosening the mounting screws, then remove the rear back armrest cup holder (A).

7.

Installation is the reverse of removal.

•	Make sure the connectors are plugged in properly.

•	Replace any damage clips.

Rear Back Armrest Cup Holder Components and Components Location

Component Location 1. Rear back armrest cup holder ...

Front Seat Belt

...

See also:

Specifications
Specifications IMS Electrical System ItemSpecificationRating voltageDC 12VOperating voltageDC 9V ~ 16VOperating temperature-30°C ~ +80°CMaintaining temperature-40°C ~ +85°CMax, humid95%Consumption ...

Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram ...

Categories

Hyundai Azera Manuals

© 2011-2024 Copyright www.hgmanual.com