Inspection (With GDS) |
1. |
Check BCM input/output specification of multifunction switch
using the GDS. If the specification is abnormal, replace the lamp or
wiper switch. |
2. |
If diagnosis is required on the multifunction switch, select model and "BCM - Multifunction switch". |
3. |
To consult the present input/output value of Multifunction switch, "Current DATA". |
Removal |
1. |
Remove the steering column upper and lower shrouds after removing 3 screws. |
2. |
Disconnect the lighting switch and wiper & washer switch connector (A). |
3. |
If necessary of removing the wiper & washer switch (A)
only, release the lock of wiper switch using tool without removing the
steering wheel and the clock spring.
|
4. |
Remove the steering wheel.
|
5. |
Remove the clock spring.
|
6. |
Remove the multifunction switch assembly (A) after loosening the mounting screws (2EA). |
Installation |
1. |
Install the multifunction switch. |
2. |
Install the clock spring and steering. |
3. |
Install the steering column upper and lower shrouds. |
4. |
Install the steering wheel.
|
Center Fascia Panel Components and Components Location
Component Location
1. Center fascia panel
...
Rear Seat Belt Buckle Repair procedures
Replacement
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Loosen the mounting bolt, and then remove the rear seat belt buckle (A).
[LH]
Tighten ...
Wipers & Washers
...