Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the main crash pad.
|
3. |
Remove the interior 1 antenna (A) after disconnecting the connector and loosening the mounting nuts (2EA). |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the center console.
|
3. |
Remove the interior 1 antenna (A) after loosening the mounting nuts (2EA). |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the trunk transverse trim.
|
3. |
Disconnect the trunk antenna connector (A) and remove the trunk antenna (B) after loosening screws (2EA). |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the rear bumper.
|
3. |
Disconnect the exterior bumper antenna connector on rear bumper center part. |
4. |
Disconnect the antenna connector and remove the exterior bumper antenna (A) after loosening the screws (2EA). |
Installation |
1. |
Install the interior 1 antenna. |
2. |
Install the main crash pad. |
3. |
Install the negative (-) battery terminal and check the smart key system. |
1. |
Install the interior 2 antenna. |
2. |
Install the center console. |
3. |
Install the negative (-) battery terminal and check the smart key system. |
1. |
Install the trunk antenna. |
2. |
Install the trunk tranverse trim. |
3. |
Install the negative (-) battery terminal and check the smart key system. |
1. |
Install the exterior bumper antenna. |
2. |
Install the rear bumper. |
3. |
Install the negative (-) battery terminal and check the smart key system. |
Front Stabilizer Bar Repair procedures
Replacement
1.
Remove the front wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
•
Be careful not to damage to the hub b ...
Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
Circuit Diagram
...
Starter Relay Repair procedures
Inspection
1.
Remove the fuse box cover.
2.
Remove the starter relay (A).
3.
Using an ohmmeter, check that there is continuity between each terminal.
TerminalContinuity30 - 87NO85 - 86Y ...