Inspection |
1. |
Remove the front door trim.
|
2. |
Remove the front door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the rear door trim.
|
2. |
Remove the rear door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the trunk lid trim panel.
|
2. |
Disconnect the 3P connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the front door trim panel.
|
2. |
Remove the front door module. |
3. |
Disconnect the 6P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table. |
1. |
Remove the rear door trim panel.
|
2. |
Remove the rear door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Remove the trunk lid trim.
|
2. |
Disconnect the 3P connector from the actuator. |
3. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Disconnect the connector from the hood switch (A). |
2. |
Check for continuity between the terminals and ground according to the table. |
1. |
Remove the burglar horn (A) after removing 1 bolt and disconnect the 2P connector from the burglar horn. |
2. |
Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2. |
3. |
The burglar horn should make a sound. If the burglar horn fails to make a sound replace it. |
Anchor Pretensioner (APT) Components and Components Location
Components
...
Display Settings
Adjusting the Brightness
Press the key
Select [Display]
Select [Brightness]
Use ,
keys to adjust the screen brightness
or set the Brightness on Automatic, Daylight, or Nightmode.
select t ...
Injector Troubleshooting
Signal Waveform
...