Inspection |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the floor console upper cover.
|
3. |
Remove the seat heater switch connector (A) from the floor console upper cover. |
4. |
Remove the seat heater switch assembly after loosining the screws (4EA). |
5. |
Operate driver seat heater switch and check that continuity exists between the terminals.
If there is no continuity, replace the seat heater switch |
6. |
Operate assist seat heater switch and check that continuity exists between the terminals.
If there is no continuity, replace the seat heater switch |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Open the rear seat armrest (A). |
3. |
Remove the rear seat armrest upper cover (A).
|
4. |
Remove the seat heater switch assembly and cover (A).
|
5. |
Remove the seat heater switch assembly (A) after disconnecting the connector and loosening the screws. |
6. |
Turn rear seat heater switch ON and check that continuity exists between the terminals. |
7. |
If there is no continuity, replace the seat heater switch. |
Thermostat Repair procedures
Removal
Removal of the thermostat would have an adverse effect,
causing a lowering of cooling efficiency. Do not remove the thermostat,
even if the engine tends to overhea ...
Trunk Lid Key Holder Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...
Purge Control Solenoid Valve (PCSV) Schematic Diagrams
Circuit Diagram
...