In the OFF position, pull the lever gently toward you to spray washer fluid on the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wiper operation will continue until you release the lever. If the washer does not work, check the washer fluid level. If the fluid level is not sufficient, you will need to add appropriate non-abrasive windshield washer fluid to the washer reservoir.
The reservoir filler neck is located in the front of the engine compartment on the passenger side.
CAUTION - Washer pump
To prevent possible damage to the washer pump, do not operate the washer when the fluid reservoir is empty.
WARNING - Obscured visibility
Do not use the washer in freezing temperatures without first warming the windshield with the defrosters; the washer solution could freeze on contact with the windshield and obscure your vision.
CAUTION - Wipers & Windshields
Components and Components Location
Components
1. Sub frame2. Lower arm3. Front disk4. Drive shaft5. Steering gearbox6. Front stabilizer bar7. Front strut assembly8. Front stabilizer bar link
...
Valve Body Components and Components Location
Components Location
1. PCV adjust screw2. Solenoid valve3. Oil temperature sensor4. Accumulator5. Low & reverse brake(LR/B) pressure flow hole6. Under drive brake (UD/B) pressure flow hole
...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Specifications
Specifications
Direct control VFS[OD/C]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81 (5.1 ~ 0.1, 72.54 ~ 1.42)Current value(mA)50~850 Internal resis ...