Fuse Inspection |
1. |
Be sure there is no play in the fuse holders, and that the fuses are held securely. |
2. |
Are the fuse capacities for each circuit correct? |
3. |
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse of the
same capacity. Always determine why the fuse blew first and completely
eliminate the problem before installing a new fuse. |
Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the crash pad lower panel.
|
3. |
Disconnect the connectors (A) from the IPM (Intelligent intergrated Platform Module). |
4. |
Remove the IPM after loosening the mounting nuts (4EA). |
5. |
Disconnect the connectors from the back side of the IPM. |
Installation |
1. |
Install IPM (Intelligent intergrated Platform Module). |
2. |
Connect the IPM connector. |
3. |
Install the crash pad lower panel. |
Description and Operation
Description
Automatic transaxle system relies on various measurement data
to determine the current control status and extrapolate the necessary
compensation values. These values are used to con ...
Digital clock (if equipped)
WARNING
Do not adjust the clock while driving. You may lose your steering control
and cause an accident that results in severe personal injury or death.
Whenever the battery terminals or relate ...
Valve Body Repair procedures
Removal
1.
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
2.
Remove the under cover (A).
Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ...