Inspection |
1. |
There should be continuity between the No.18 and No.17
terminals when power and ground are connected to the No.16 and No.17
terminals. |
2. |
There should be no continuity between the No.18 and No.17 terminals when power is disconnected. |
1. |
There should be continuity between the No.8 and No.3
terminals when power and ground are connected to the No.5 and No.6
terminals. |
2. |
There should be no continuity between the No.8 and No.3 terminals when power is disconnected. |
1. |
There should be continuity between the No.1 and No.12
terminals when power and ground are connected to the No.2 and No.11
terminals. |
2. |
There should be no continuity between the No.1 and No.12 terminals when power is disconnected. |
Outside Rear View Mirror Components and Components Location
Component Location
1. Outside rear view mirror
...
Tie-down hook
WARNING - Tie-down hook
Do not use the tie-down hooks for towing purposes. These hooks are designed
ONLY for transport tie-down. If the tiedown hooks are used for towing, the tie-down
hooks or defl ...
Timing Chain Repair procedures
Removal
1.
Set No.1 cylinder to TDC/compression.
(1)
Turn the crankshaft pulley clockwise and align its groove with the timing mark "T" of the lower timing chain cover.
(2)
Check that the m ...