Inspection |
1. |
Remove the front door trim.
|
2. |
Remove the front door module. |
3. |
Disconnect the connector (7P) from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the rear door trim.
|
2. |
Remove the rear door module. |
3. |
Disconnect the connector (7P) from the actuator. |
4. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the trunk lid trim panel.
|
2. |
Disconnect the 3P connector from the actuator. |
3. |
Check actuator operation by connecting power and ground
according to the table. To prevent damage to the actuator, apply battery
voltage only momentarily. |
1. |
Remove the front door trim panel.
|
2. |
Remove the front door module. |
3. |
Disconnect the 6P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position when inserting the key into the door according to the table. |
1. |
Remove the rear door trim panel.
|
2. |
Remove the rear door module. |
3. |
Disconnect the 7P connector from the actuator. |
4. |
Check for continuity between the terminals in each switch position according to the table. |
1. |
Remove the trunk lid trim.
|
2. |
Disconnect the 3P connector from the actuator. |
3. |
Check for continuity between the terminals in each switch position according to the table. |
Specifications
Specifications
ItemSpecificationsTransmission typeA6LF2Engine modelGasoline 3.3 GDITorque converter type3-element, 1-stage, 2-phase typeTorque converter sizeO260 mm (10.2362 in.)Oil pump sy ...
ICM (Integrated Circuit Module) Relay Box Components and Components Location
Component
Input/Output Specification
No.ConnectorNo.Connector1 -11 -2 -12 -3Burglar horn13 -4 -14 -5Engine room box(Horn 15A fuse)15GND6IPM(BCM : Burglar alarm h ...
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid(ATF) level is not
normally required during scheduled services. If an oil leak is found, ...