Inspection |
1. |
It will be able to diagnose defects of DDM/ADM with GDS
quickly. GDS can operates actuator forcefully, input/output value
monitoring and self diagnosis. |
2. |
Select model and "IPM". |
3. |
Select the "DDM" to check. |
4. |
Select "Input/output monitoring", if you will check current
data of power door lock system. It provides input/output status of
DDM/ADM. |
5. |
If you will check the power door lock operation forcefully, select "Actuation test". |
6. |
To check the DTC of the DDM/ADM module, select "Diagnostic trouble codes" |
Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the front door trim panel.
|
3. |
Disconnect the power window switch module connector (A) from the wiring harness. |
4. |
Remove the power window switch module (B) from the door trim after loosening the mounting screws. |
Installation |
1. |
Install the power window switch module. |
2. |
Install the door trim panel after reconnecting the relevant connectors
|
Oil Filter Repair procedures
Replacement
1.
Remove the engine cover.
2.
Wait for 5 minutes after loosening the oil filter cap to drain well the oil in the oil filter.
3.
Replace the oil filter.
(1)
Disconnect the ...
Side Airbag (SAB) Module Components and Components Location
Components
...
Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the steering wheel.
(Refer to Steering ...