Inspection |
1. |
Remove the front door quadrant delta cover.
|
2. |
Disconnect the power door mirror connector from the harness. |
3. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Mirror Heater Inspection
Puddle Lamp
ECM
Side Repeater Lamp
Folding Mirror
Memory Mirror Inspection |
Hands Free Switch Schematic Diagrams
Circuit Diagram
...
Body Control Module (BCM) Schematic Diagrams
BCM Connector Terminals
BCM(IPM) Input Signal SPEC
Signal NameOn/Off JudgmentInput CharacteristicsInput acquisition VBAT Threshold VoltageL_DRLOpt(NA)On : 3.2V UnderOff : 4.2V OverPull up(ON ...
Steering Gear box Components and Components Location
Components
1. Tie-rod end2. Lock nut3. Bellows clip4. Bellows5. Tie rod6. Rack bar7. Dust packing8. Dust cap9. Oil seal10. Pinion plug11. Pinion assembly12. Yoke plug13. Yoke spring14. Support yo ...