Inspection |
1. |
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative (-) battery cables to terminal 2 respectively. |
3. |
Check that the motor operates normally and the washer motor runs and water sprays from the front nozzles. |
4. |
If they are abnormal, replace the washer motor.
|
1. |
Disconnect the negative(-) battery terminal. |
2. |
Drain the washer fluid less than 650 cc. |
3. |
Check for continuity between the No. 1 and No.2 terminal in each float position.
There should be continuity when the float is down.
There should be no continuity when the float is up. |
4. |
If the continuity is not as specified, replace the washer fluid level switch. |
Removal |
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the right tire in the front and wheel cover. |
3. |
Remove the washer hose (B) and disconnect the washer motor connector (A). |
4. |
Remove the washer motor.
|
5. |
Remove the washer tank (B) after loosening the washer tank mounting bolt (A). |
Installation |
1. |
Install the washer reservoir.
|
2. |
Install the washer motor. |
3. |
Install the washer hose. |
4. |
Connect the washer motor connector and level sensor connector. |
5. |
Install the tire and wheel guide cover. |
6. |
Check the washer motor operation. |
Disarmed stage
The system will be disarmed when:
- The door unlock button is pressed on the smart key.
- The switch of the front outside door is pressed while carrying the smart key.
- The door is opened with the ...
Battery replacement
A smart key battery should last for several years, but if the smart key is not
working properly, try replacing the battery with a new one. If you are unsure how
to use your smart key or replace the ...
Room Lamp Repair procedures
Removal
Room lamp(General type)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the room lamp assembly (A) with (-) screwdriver.
3.
Remove the LED bulb (A).
Room lamp(Panoram ...