Removal |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the room lamp assembly (A) with (-) screwdriver. |
3. |
Remove the LED bulb (A). |
1. |
Remove the lens (A) with (-) screwdriver. |
2. |
Replace the bulb after disconnecting a connector. |
1. |
Disconnect the negative(-) battery terminal. |
2. |
Remove the lens (A) with pushing the fixing clip (B). |
3. |
Replace the bulb after disconnecting a connector. |
1. |
Remove the crash pad LH garnish assembly.
|
2. |
Remove the LH mood lamp (A) after disconnection a connector. |
1. |
Remove the crash pad RH garnish assembly.
|
2. |
Remove the RH mood lamp (A) after disconnection a connector. |
Installation |
1. |
Connect a connector. |
2. |
Install the lamp assembly. |
3. |
Install the lens. |
1. |
Install the vanity lamp. |
Dimensions
...
Photo Sensor Repair procedures
Inspection
1.
Ignition "ON"
2.
Using the scan tool.
3.
Emit intensive light toward photo sensor using a lamp, and check the output voltage change.
4.
The voltage will rise with higher ...
Manifold Absolute Pressure Sensor (MAPS) Specifications
Specification
Pressure [kPa (kgf/cm?, psi)]Output Voltage (V)20.0 (0.20, 2.90)0.7946.66 (0.47, 6.77)1.84101.32 (1.03, 14.7)4.0
...