Remove the overhead console lamp assembly then check for
continuity between terminals. If the continuity is not as specified,
replace the map lamp switch.
No.
| Description
| No.
| Description
|
1
| -
| 4
| Room door
|
2
| GND (-)
| 5
| Mood (+)
|
3
| Door (-)
| 6
| Battery (+)
|
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the overhead console lamp assembly with removal. |
3. |
Remove the overhead console lamp after disconnecting the panoramaroof switch connector and lamp connector (A). |
4. |
If necessary to replace the bulb, replace the bulb (B). |
1. |
Install the overhead console lamp after connecting the panoramaroof switch connector and lamp connector. |
2. |
Install the lens after tightening 2 screws. |
Removal
Room lamp(General type)
1.
Disconnect the negative(-) battery terminal.
2.
Remove the room lamp assembly (A) with (-) screwdriver.
3.
Remove the LED bulb (A).
Room lamp(Panoram ...
Removal
Mood lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
3.
Remove the connector(A) and door LED mood l ...
See also:
Console Armrest Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Take ...
Components and Components Location
Components
Rear Seat Back [RH]
1. Headrest2. Headrest guide3. Rear seat back pad4. Rear seat back cover5. Rear seat back pad support wire6. Rear back armrest7. Hinge bracket cover8. Rear seat ...
ESC OFF Switch Description and Operation
Description
1.
The ESC OFF switch is for the user to turn off the ESC system.
2.
The ESC OFF lamp is on when ESC OFF switch is engaged. ...