Rear Combination Lamp (Outside) |
1. |
Disconnect the negative (-) battery terminal. |
2. |
If the bulbs should be only replaced without removing lamp assembly, replace the turn signal lamp bulb (A). |
3. |
Remove the nuts (4EA). |
4. |
Remove the rear combination lamp (A) after disconnecting the connector. |
1. |
Disconnect the negative (-) battery terminal. |
2. |
If the bulbs should be only replaced without removing lamp
assembly, replace the back up lamp bulb (A) after removing the trim
cover in the trunk. |
3. |
Remove the rear garnish assembly (A). |
Installation |
1. |
Install the rear combination lamp assembly after assembling the bulb. |
Front Seat Back Cover Components and Components Location
Component Location
1. Front seat back cover
...
BJ Boot Repair procedures
Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
3.
Remove ...
Don't let ice and snow accumulate underneath
Under some conditions, snow and ice can build up under the fenders and interfere
with the steering. When driving in severe winter conditions where this may happen,
you should periodically check unde ...