Inspection |
Removal |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver. |
3. |
Remove the auto light sensor connector (B). |
Installation |
1. |
Reconnect the auto light sensor connector. |
2. |
Install the auto light sensor. |
Vehicle curb weight
This is the weight of your new vehicle when you picked it up from your dealer
plus any aftermarket equipment. ...
Recommended cold tire inflation pressures
All tire pressures (including the spare) should be checked when the tires are
cold. “Cold Tires” means the vehicle has not been driven for at least three hours
or driven less than 1 mile (1.6 km).
...
Air Ventilation Seat Schematic Diagrams
Circuit Diagram
...