Hyundai Azera: Immobilizer Control Unit Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit Repair procedures
| Removal |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the crash pad lower panel.
|
| 3. |
Disconnect the connector of the immobilizer unit and then remove the immobilizer unit (A) after loosening the nut.
|
| Installation |
| 1. |
Install the immobilizer control unit after connecting the unit connector. |
| 2. |
Install the crash pad lower panel.
|
Repair procedures
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner.
The procedure starts with a ...
Antenna Coil Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect the 6P connector (B) of the coil ante ...
See also:
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The measured resistance at high ...
Description and Operation
Description
Tread Lamp
-
Tire Under Inflation / Leak Warning.
1.
Turn on condition
A.
When tire pressure is below allowed threshold
B.
When rapid leak is detected by the sensor.
2 ...
Anchor Pretensioner (APT) Description and Operation
Description
Front seat belt anchor pretensioner operates as well as belt
pretensioner at the same time If it gets into its deploy condition after
a collision. It is located at near anchor on fr ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com