Removal |
1. |
Remove the front bumper.
|
2. |
Pull out the front sensor (A) from the sensor holder by opening the sensor holder out. |
3. |
Disconnect the connector from the front sensor. |
1. |
Remove the rear bumper.
|
2. |
Pull out the rear sensor (A) from the sensor holder by opening the sensor holder out. |
3. |
Disconnect the connector from the rear sensor. |
Installation |
1. |
Install the parking assist sensor to the bumper. |
2. |
Connect the connector. |
3. |
Install the corresponding bumper. |
Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation
Description
Torque converter control solenoid valve (T/CON) is attached
to the valve body. This variable force solenoid valve directly controls
the hydraulic pressure inside the torque converte ...
Power Door Lock Actuators Repair procedures
Inspection
Front Door Lock Actuator Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front door module.
3.
Disconnect the connector (7P) from t ...
Cylinder Head Components and Components Location
Components
1. RH Cylinder head2. RH Cylinder head gasket3. LH Cylinder head4. LH Cylinder head gasket5. Cylinder block
1. Camshaft bearing cap 2. Camshaft thrust bearing cap 3. RH Exhaust ca ...