Removal |
1. |
Remove the front bumper.
|
2. |
Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A). |
1. |
Open the trunk and remove the rear garnish assembly.
(Refer to Lighting System - "Rear Combination Lamp") |
2. |
Disconnect the connector and loosen 2 screws. And remove the back view camera(A). |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Remove the crash pad lower panel in the driver side.
|
3. |
Remove the crash pad switch assembly(A) by pushing both clips.
|
Installation |
1. |
Install the front view camera. |
2. |
Install the front bumper. |
1. |
Install the rear view camera. |
2. |
Install the rear garnish assembly. |
1. |
Connect the connector and install the side switch assembly. |
Manifold Absolute Pressure Sensor (MAPS) Description and Operation
Description
Manifold Absolute Pressure Sensor (MAPS) is a speed-density
type sensor and is installed on the surge tank. It senses absolute
pressure of the surge tank and transfers the analog si ...
Rear Wheel Guard Repair procedures
Replacement
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage.
•
Put ...
Using Voice Recognition
Starting Voice Recognition
Shortly press the key on the steering
wheel remote controller. Say a command.
If prompt feedback is in [ON], then the system will say “Please say a command
after the ...