Inspection |
1. |
Measure the pressure of high pressure line by measuring voltage output between NO.1 and NO.2 terminals. |
2. |
Inspect the voltage value whether it is sufficient to be regular value or not.
|
3. |
If the measured voltage value is not specification, replace the A/C pressure transducer. |
Replacement |
1. |
Disconnect the negative (-) battery terminal. |
2. |
Recover the refrigerant with a recovery/charging station. |
3. |
Disconnect the A/C pressure transducer connector (A) and then remove the A/C pressure transducer (B).
|
4. |
Installation is the reverse order of removal. |
Valve clearance
Inspect excessive valve noise and/or engine vibration and adjust if necessary.
An authorized HYUNDAI dealer should perform the operation. ...
General Information
The Micro 570 Analyzer (Canada only)
The Micro 570 Analyzer provides the ability to test the
charging and starting systems, including the battery, starter and
alternator.
...
Oil Filter Body Repair procedures
Removal and Installation
1.
Remove the water pipe.
(Refer to Cooling System - "Water Pipe")
2.
Wait for 5 minutes after loosening the oil filter cap to drain well the oil in the oil filter.
...