Press the key
Select [Phone]
Select [Pair Phone]
Select
TUNE knob
1.The following steps are the same as those described in the section "When No
Devices have been Paired" on the previous page.
✽ NOTICE
- Bluetooth® Wireless Technology features supported within the vehicle
are as follows. Some features may not be supported depending on your Bluetooth®
Wireless Technology device. Outgoing/Incoming Handsfree calls Operations during
a call (Switch to Private, Switch to call waiting, MIC on/off) Downloading Call
History Downloading Mobile Contacts Bluetooth® Wireless Technology device auto
connection Bluetooth Audio Streaming
- Up to five Bluetooth® Wireless Technology devices can be paired to the
Car Handsfree system.
- Only one Bluetooth® Wireless Technology device can be connected at a
time.
- Other devices cannot be paired while a Bluetooth® Wireless Technology
device is connected.
- Only Bluetooth® Wireless Technology Handsfree and Bluetooth audio related
features are supported.
- Bluetooth related operations are possible only within devices that support
Handsfree or audio features, such as a Bluetooth® Wireless Technology mobile
phone or a Bluetooth audio device.
- If a connected Bluetooth® Wireless Technology device becomes disconnected
due to being out of communication range, turning the device OFF, or a Bluetooth®
Wireless Technology communication error, corresponding Bluetooth® Wireless Technology
devices are automatically searched and reconnected.
- If the system becomes unstable due to communication errors between the
car Handsfree and the Bluetooth® Wireless Technology device, reset the device
by turning off and back on again. Upon resetting Bluetooth® Wireless Technology
device, the system will be restored.
- After pairing is complete, a contacts download request is sent once to
the mobile phone. Some mobile phones may require confirmation upon receiving
a download request, ensure your mobile phone accepts the connection. Refer to
your phones user’s manual for additional information regarding phone pairing
and connections.
When No Devices have been Paired
1. Press the key or the
key on the steering remote controller.
The following screen is displayed.
2. Select the button to enter the
Pair Phone screen.
1) ...
Press the key
Select [Phone]
Select [Paired Phone List]
1) Connected Phone : Device that is currently connected
2) Paired Phone : Device that is paired but not connected
From the ...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Crankshaft Position Sensor (CKPS) Repair procedures
Inspection
1.
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
Removal
1.
Turn the ignition switch OFF and disconnect the battery negat ...
Canister Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the ventilation hose (A) from the fuel tank air filter.
3.
Disconnect the vapor tube q ...