Removal and Installation |
[Engine mounting support bracket] |
1. |
Install the jack to the edge of upper oil pan (A) to support the engine.
|
2. |
Disconnect the ground cable (A), and then remove the engine mounting support bracket (B).
|
3. |
Install in the reverse order of removal. |
[Engine mounting bracket] |
1. |
Remove the reservoir tank.
(Refer to Cooling System - "Reservoir Tank") |
2. |
Remove the engine mounting support bracket (A).
|
3. |
Remove the engine mounting bracket (B).
|
4. |
Install in the reverse order of removal. |
[Roll rod bracket] |
1. |
Remove the engine room under cover. |
2. |
Remove the roll rod bracket (A).
|
3. |
Install in the reverse order of removal. |
Input Speed Sensor Specifications
Specifications
? Type: Hall effect sensor
Operation condition [°C(°F)](-40~150) -40~302Air gap(mm)in.(0.95~1.65)0.037~0.065Output voltage(V)High1.18~1.68Low0.59~0.84
...
Blade replacement
When the wipers no longer clean adequately, the blades may be worn or cracked,
and require replacement.
CAUTION
To prevent damage to the wiper arms or other components, do not attempt
to move ...
Troubleshooting
Troubleshooting
Trouble SymptomProbable causeRemedyVehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceTire conicity (rotate tires, repl ...