Hyundai Equus Manuals

Hyundai Azera: Crankshaft Damper Pulley Repair procedures - Timing System - Engine Mechanical System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Crankshaft Damper Pulley Repair procedures

Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley Repair procedures

Removal and Installation
   
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors carefully while holding the connector portion.
   
Mark all wiring and hoses to avoid misconnection.
1.
Remove the battery and battery tray.
2.
Remove the engine cover.
3.
Remove the air duct and air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner")
4.
Remove the engine room under cover.
5.
Remove the front muffler.
(Refer to Intake And Exhaust System - "Front Muffler")
6.
Remove the crankshaft damper pulley (A).
Tightening torque :
284.4 ~304.0N.m (29.0~31.0kgf.m, 209.8~224.2lb-ft)

   
There are two methods to hold the ring gear when installing or removing the crankshaft damper pulley.
•
Install the SST (09231-2B100) to hold the ring gear after removing the starter.

•
Install the SST (09231-3D100) to hold the ring gear after removing the dust cover.
1.
Remove the front muffler.
(Refer to Intake And Exhaust System - "Front Muffler")
2.
Remove the dust cover (A) on the bottom of the upper oil pan and unfasten the two transaxle mounting bolts (B).

3.
Adjust the length of the holder nuts (A) so that the front plate of the holder (B) puts in the ring gear (C) teeth.
4.
Fasten the two transaxle mounting bolts in the original mounted holes.

5.
Install the SST (09231-3D100) using the two mounting bolts. Tighten the bolts and nuts of the holder securely.

7.
Install in the reverse order of removal.
Crankshaft Damper Pulley Components and Components Location
Components 1. Crankshaft damper pulley ...

Front Oil Seal Components and Components Location
Components 1. Front oil seal ...

See also:

Catalytic Converter Repair procedures
Removal [Catalytic Converter (WCC)] 1. Remove the exhaust manifold. (Refer to Engine Mechanical System - "Exhaust Manifold") [Catalytic Converter (UCC)] 1. Remove the Center Muffler. ...

Compressor Repair procedures
Removal 1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. 2. Disconnect the negati ...

Hood Assembly Repair procedures
Replacement     • When removing and installing the hood, an assistant is necessary. • Be careful not to damage the hood and body. • When removing the clips, use a c ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com