Hyundai Azera: Front Oil Seal Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Mechanical System / Timing System / Front Oil Seal Repair procedures
Fifth generation HG (2011–2024) / Hyundai Azera 2011-2024 Service Manual / Engine Mechanical System / Timing System / Front Oil Seal Repair procedures
| Removal |
| 1. |
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley") |
| 2. |
Remove the front oil seal (A).
|
| Installation |
| 1. |
Using SST(09231-3C100), install timing chain cover oil seal.
|
| 2. |
Install the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley") |
Front Oil Seal Components and Components Location
Components
1. Front oil seal
...
Timing Chain Cover Components and Components Location
Components
1. Timing chain cover2. Gasket
...
See also:
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wip ...
Rear Shock Absorber Repair procedures
Replacement
1.
Remove the rear wheel & tire (A).
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
Be careful not to damage to the hub bolts w ...
Cluster ionizer Repair procedures
Inspection
1.
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
DisplayFail description00Normal50Cluster ionizer fault
* Diagnostic procedure refer to D ...
Categories
Hyundai Azera Manuals
© 2011-2024 Copyright www.hgmanual.com