Removal |
[RH] |
1. |
Remove the RH bank timing chain.
(Refer to Timing System - "Timing Chain") |
2. |
Remove the RH exhaust CVVT oil control valve.
|
3. |
Remove the RH camshaft bearing cap (A) and thrust bearing cap (B). |
4. |
Remove the RH intake camshaft (A) and exhaust camshaft (B) |
[LH] |
1. |
Remove the RH/LH timing chain.
(Refer to Timing System - "Timing Chain") |
2. |
Remove the LH exhaust CVVT oil control valve.
|
3. |
Remove the fuel pump bracket (A) |
4. |
Remove the LH camshaft bearing cap (A) and thrust bearing cap (B). |
5. |
Remove the LH intake camshaft (A) and exhaust camshaft (B) |
Installation |
|
[RH] |
1. |
Install the RH intake camshaft (A) and exhaust camshaft (B)
RH Inkate camshaft
As for camshaft identification, refer to the table below.
RH Exhaust camshaft
As for camshaft identification, refer to the table below.
|
2. |
Install the bearing cap (A) and thrust bearing cap (B) with specified torque.
A : L(LH),R(RH)
B : I(Intake), None(Exhaust)
C : Journal number
D : Front mark
|
3. |
Install the other parts reverse order of removal. |
[LH] |
1. |
Install the LH intake camshaft (A) and exhaust camshaft (B)
LH Inkate camshaft
As for camshaft identification, refer to the table below.
LH Exhaust camshaft
As for camshaft identification, refer to the table below.
|
2. |
Install the bearing cap (A) and thrust bearing cap (B) with specified torque.
A : L(LH),R(RH)
B : I(Intake), None(Exhaust)
C : Journal number
D : Front mark
|
3. |
Install the fuel pump bracket (A)
|
4. |
Install the other parts reverse order of removal. |
Evaporator Temperature Sensor Repair procedures
Inspection
1.
Ignition "OFF".
2.
Disconnect evaporator temperature sensor.
3.
Using the multi-tester, Measure resistance between terminal "1" and "2" of evaporator temperature sensor.
Spe ...
Components and Components Location
Component Location
1. Fender
...
Engine Coolant Temperature Sensor (ECTS) Schematic Diagrams
Circuit Diagram
...