Removal |
1. |
Remove the drive plate.
(Refer to Cylinder Block - "Drive Plate") |
2. |
Remove the rear oil seal (A). |
Installation |
1. |
Using SST(09231-3C200, 09231-H1100), install the rear oil seal.
|
2. |
Install the drive plate.
(Refer to Cylinder Block - "Drive Plate") |
Rear Door Side Weatherstrip Repair procedures
Replacement
1.
Detach the clips, then remove the rear door side weatherstrip (A).
2.
Installation is the reverse of removal.
•
Replace any damaged clips.
...
Symbols used in this manual
Warnings, cautions and Notices
WARNING
A WARNING indicates a situation in which harm, serious bodily injury or death
could result if the warning is ignored.
CAUTION
A CAUTION indicates a situatio ...
Cluster ionizer Repair procedures
Inspection
1.
Press the OFF switch more then 4 times within 2 seconds while pressing the MODE switch.
DisplayFail description00Normal50Cluster ionizer fault
* Diagnostic procedure refer to D ...