Removal and Installation |
1. |
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator Hose") |
2. |
Remove the cooling fan assembly.
(Refer to Cooling System - "Cooling Fan") |
3. |
Disconnect the ATF cooler hoses.
|
4. |
Disconnect the over flow hose.
(Refer to Cooling System - "Reservoir Tank") |
5. |
Remove the radiator mounting brackets (A).
|
6. |
Separate the condenser from the radiator and then pull radiator (A) up and remove it from engine room. |
7. |
Installation is in the reverse order of removal. |
8. |
Fill the radiator with coolant and check for leaks.
|
Inspection |
1. |
Remove the radiator cap, wet its seal with engine coolant, and then install it on a pressure tester. |
2. |
Apply a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm?, 13.51 ~ 17.78psi). |
3. |
Check for a drop in pressure. |
4. |
If the pressure drops, replace the cap. |
1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install it on the
pressure tester. |
2. |
Apply a pressure tester to the radiator and apply a pressure of 93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm?, 13.51 ~ 17.78psi). |
3. |
Inspect for engine coolant leaks and a drop in pressure. |
4. |
Remove the tester and reinstall the radiator cap.
|
Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Battery Description and Operation
Description
1.
The maintenance-free battery is, as the name implies, totally maintenance free and has no removable battery cell caps.
2.
Water never needs to be added to the maintenance-free b ...
Parking Assist Sensor Repair procedures
Removal
[Front parking assist sensor]
1.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
2.
Pull out the front sensor (A) from the sensor holder by opening the sensor holder ...