Hyundai Equus Manuals

Hyundai Azera: Water Temperature Control Assembly Repair procedures - Cooling System - Engine Mechanical System - Hyundai Azera 2011-2024 Service ManualHyundai Azera: Water Temperature Control Assembly Repair procedures

Removal and Installation
1.
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator Hose")
2.
Disconnect the throttle body water hoses.
3.
Disconnect the heater hoses.
(Refer to Cooling System - "Heater Hose")
4.
Disconnect the WTS & gauge unit connector (A)

5.
Separate the engine wiring protector mounted on the water temperature control assembly.
   
When installing, be sure to install the wiring protector mounting bolts of the original.
If other bolts(longer or larger) has been installed, this can damage the water temperature control assembly and coolant may be leak.
6.
Remove the water temperature control assembly (A) and the gaskets.

Tightening torque:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)

   
When installing, install the gasket with new one.
7.
Install in the reverse order of removal.
Water Temperature Control Assembly Components and Components Location
Components 1. Water temperature control assembly2. Throttle body water hose3. Gasket ...

Water Pipe Components and Components Location
Components 1. Water center pipe2. O-ring ...

See also:

Troubleshooting
Failure Diagnosis 1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is prohibited. 3. However, when the ...

Emission control system
The emission control system of your vehicle is covered by a written limited warranty. Please see the warranty information contained in the Owner’s Handbook & Warranty Information booklet in your ...

Height Adjust Components and Components Location
Component Location 1. Height adjust ...

Categories

Hyundai Azera Manuals


© 2011-2024 Copyright www.hgmanual.com