Removal and Installation |
1. |
Remove the water pipe.
(Refer to Cooling System - "Water Pipe") |
2. |
Remove the oil pressure switch (A).
|
3. |
Installation is in the reverse order of removal. |
Inspection |
1. |
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch. |
2. |
Check the continuity between the terminal and the body when
the fine wire is pushed. If there is continuity even when the fine wire
is pushed, replace the switch. |
3. |
If there is no continuity when a 50 kpa (7psi) is applied
through the oil hole the switch is operaing properly. Check for air
leakage. If air leaks, the diaphragm is broken. Replace it. |
Front Seat Assembly Components and Components Location
Component Location
1. Front seat assembly
...
Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the or
position during cooling operation
in extremely humid weather. The difference between the temperature of the outside
air and that of t ...
Components and Components Location
Components
1. Gear knob & Gear boots2. Console upper tray complete3. Center facia side garnish [RH]4. Center facia side garnish [LH]5. Console extension cover [RH]6. Console extension cover [ ...