Inspection |
1. |
Remove the fuse box cover. |
2. |
Remove the starter relay (A). |
3. |
Using an ohmmeter, check that there is continuity between each terminal.
|
4. |
Apply 12V to terminal 85 and ground to terminal 86.
Check for continuity between terminals 30 and 87. |
5. |
If there is no continuity, replace the starter relay. |
6. |
Install the starter relay. |
7. |
Install the fuse box cover. |
Console Armrest Components and Components Location
Component Location
1. Console armrest
...
Rain Sensor Repair procedures
Inspection
Rain Sensing Wiper
1.
In IGN2 ON state, if auto switch input (LIN communication) is
ON then both wiper low relay and wiper high relay outputs are
controlled by the rain sensor inpu ...
Cruise Control Switch Repair procedures
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4lb-ft)
2.
Remove the steering wheel.
(Refer to Steering ...