Removal |
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
|
When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the ECM learns the smart key information
automatically.
|
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the cover. |
3. |
Disconnect the ECM connector (A). |
4. |
Remove the battery tray.
|
5. |
Remove the ECM bracket installation bolts (A) and nut (B). |
6. |
After removing the installation nuts (A), and screw (B), remove the ECM (C) from the bracket. |
Installation |
When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
|
When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the ECM learns the smart key information
automatically.
|
1. |
Installation is reverse of removal.
|
ECM Problem Inspection Procedure |
1. |
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and
chassis ground using the backside of ECM harness connector as ECM side
check point. If the problem is found, repair it.
|
2. |
TEST ECM CONNECTOR: Disconnect the ECM connector and visually
check the ground terminals on ECM side and harness side for bent pins
or poor contact pressure. If the problem is found, repair it. |
3. |
If problem is not found in Step 1 and 2, the ECM could be
faulty. If so, replace the ECM with a new one, and then check the
vehicle again. If the vehicle operates normally then the problem was
likely with the ECM. |
4. |
RE-TEST THE ORIGINAL ECM: Install the original ECM (may be
broken) into a known-good vehicle and check the vehicle. If the problem
occurs again, replace the original ECM with a new one. If problem does
not occur, this is intermittent problem (Refer to “Intermittent
Problem Inspection Procedure” in Basic Inspection Procedure).
|
The programmed VIN cannot be changed. When writing the VIN, confirm the VIN carefully |
1. |
Select "VIN Writing" function in "Vehicle S/W Management". |
2. |
Select "Write VIN" in "ID Register". |
3. |
Input the VIN.
|
4. |
Turn the ignition switch OFF, then back ON. |
Front Seat Assembly Repair procedures
Replacement
1.
Remove the front seat track mounting cover.
2.
After loosening the seat assembly mounting bolts, remove the front seat assembly (A).
Tightening torque :
49.0 ~ 63.7N.m (5.0 ...
Pairing a Bluetooth® Wireless Technology Device
What is Bluetooth® Wireless Technology Pairing?
Pairing refers to the process of synchronizing your Bluetooth® Wireless Technology
phone or device with the car audio system for connection. Pairing i ...
TPMS Receiver Description and Operation
Operation
1.
General Function
A.
Auto-locate/learn takes place only once per Ignition cycle.
B.
On successful completion, 4 road wheel sensor ID's, together
with their respective road whee ...