Inspection |
1. |
Turn the ignition switch OFF. |
2. |
Disconnect the ECTS connector. |
3. |
Remove the ECTS (Refer to "Removal"). |
4. |
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 3 and 4. |
5. |
Check that the resistance is within the specification.
|
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Remove the air cleaner assembly.
|
3. |
Disconnect the engine coolant temperature sensor connector (A). |
4. |
Remove the spring clip (B), and then pull the sensor from the water temperature control assembly.
|
5. |
Supplement the engine coolant.
|
Installation |
|
|
|
1. |
Installation is reverse of removal.
|
Tire maintenance
In addition to proper inflation, correct wheel alignment helps to decrease tire
wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment.
When you have new tires install ...
Cylinder Block Components and Components Location
Components
1. Piston ring2. Piston3. Connecting rod4. Connecting rod upper bearing5. Piston pin6. Connecting rod lower bearing7. Connecting rod bearing cap8. Baffle plate9. Upper oil pan10. Cylin ...
Hood Assembly Repair procedures
Replacement
•
When removing and installing the hood, an assistant is necessary.
•
Be careful not to damage the hood and body.
•
When removing the clips, use a c ...